Spiral Flush Trim Down Cut Drawer Pull Bits and 2-1/8" overall length for

and 2-1/8" overall length for use with 1/4" collets

FRONT DOOR EDGE: Creates a decorative profile along the front edge of doors

VERSATILITY: The extended nose on plunge roundover bits can also be used to trim your project

For Leigh® #70 - 8mm shank

1-7/8 Inch Cutting Length

Spiral Flush Trim Down Cut Drawer Pull Bits and 2-1/8" overall length forMaterials: Natural woods, composites, hard plastics, thin aluminum Recommended RPM: 18,000 20,000 (max 24,000) Providing state of the art results in flush trimming, this bit can perform in extremely tight corners. The bit uses a solid pilot against your project template while the down cut flutes expel chips down and away from the router, leaving a smooth top surface. TOOL SPECS: Solid carbide, down cut, flush trim spiral with 1 8" cutting diameter, 1